Soil Testing for the Home Garden: Sampling, Labs and Reading the Report

A lab soil test is the cheapest tool in gardening. For roughly $11 to $30 a state university lab measures your soil's pH and its phosphorus, potassium, calcium and magnesium, and tells you how much lime and fertilizer to add for the crop you name. Test before you start a bed, then about every three years, and more often if you feed the garden mainly with compost or manure. Home kits and probe meters are not a substitute.

Expect the result to say "too much" as often as "too little". The University of Minnesota's lab looked at 137,845 lawn and garden samples from 1988 to 2021 and found a median phosphorus reading of 68 parts per million (ppm), against 26 ppm for farm fields, where 20 ppm on that test is enough for vegetables. That is why the advice throughout this site is to test before adding lime, sulfur, phosphorus, potassium, boron or calcium.

When to test

  • Before you plant a new bed or turn lawn into garden, so lime and other slow amendments can go in first.
  • Every three years or so after that. University of Maryland Extension says every three years for vegetable gardens; Minnesota says three to five. Test more often if compost and manure are your main fertilizers, because they come with no label.
  • In fall if you can. Results are in hand before spring and lime has the winter to react. Spring before planting also works.
  • Not right after amending. Wait six to eight weeks after liming or fertilizing, and don't sample soil that is very wet.

How to take a composite sample

The lab analyzes a few spoonfuls and reports on the whole bed, so the sample has to represent the bed. That takes many small slices mixed together.

  1. Sample each area separately. The vegetable garden, the lawn, a blueberry bed and any trouble spot each get their own sample. Raised beds are sampled in the beds, not the paths.
  2. Use a clean trowel or spade and a clean plastic bucket. Fertilizer or lime dust on the tools skews the result.
  3. Take 10 to 12 or more slices from random spots, avoiding the edges and anything unusual such as an old compost pile site. Cut each slice from the surface down to 6 to 8 inches in garden beds, or about 4 inches under lawn.
  4. Break up the clods, pick out stones and roots, and mix well.
  5. Air-dry the mix on clean paper indoors. A fan is fine; an oven or heater is not. Don't mail wet soil.
  6. Send about a cup (some labs ask for two) in a zip bag with the lab's form, and name the crop on the form. Without a crop the lab cannot make a recommendation.

Where to send it

Most state land-grant universities run a soil testing lab or work with one, and your county extension office has the forms and sample bags. Results usually come back in about two weeks. The state lab is the right choice because its ratings and fertilizer recommendations are calibrated on your region's soils.

What a routine test covers
Usually included pH; a lime requirement (buffer pH or exchangeable acidity); phosphorus; potassium; calcium; magnesium; lime and fertilizer recommendations
Included at some labs, extra at others Organic matter; cation exchange capacity; micronutrients such as zinc, manganese, copper, iron and boron; a lead screening
Usually an add-on Soluble salts; nitrate; total lead and other metals; soil texture
Not tested by soil labs Plant diseases, herbicide and pesticide residues

Nitrogen is usually missing, on purpose. Plant-available nitrogen changes with temperature and moisture from week to week, so a reading describes the day you sampled and nothing more. Labs base the nitrogen recommendation on what the crop needs instead.

Lead is missing or only screened. If you grow food near a house built before 1978 or beside a busy road, ask for a total lead test; see lead in garden soil. Don't pay for soluble salts or extra micronutrients unless you have a reason, such as heavy manure use or scorched plants.

Why home kits and probe meters fall short

  • Kits are coarse on pH and unreliable on nutrients. South Dakota State University Extension ran four inexpensive kits against a commercial lab on five soils in 2025. The kits' pH readings were within about one unit of the lab's, and one kit was off by up to 1.5 units. A full unit is the difference between pH 6 and pH 7, which is the whole range a vegetable gardener works in. On phosphorus and potassium the kits disagreed with the lab and with each other: one recommended phosphorus on three soils the lab found high, and another rated potassium "high" on all five soils, including ones the lab found low.
  • The chemistry is different. Most kits shake the soil with water, which picks up only what is already dissolved. Labs use extracting solutions that also pull nutrients off the soil particles, and those methods have been matched to crop response in field trials. Labs also dry, grind and sieve the sample first, and kit reagents go off with age and heat.
  • Handheld meters are in the same class. University of New Hampshire Extension puts handheld soil meters alongside kits as typically less accurate than lab testing.
  • Neither tells you how much to apply. A lab report converts the numbers into pounds of lime and fertilizer for your crop.

A kit is good enough to show whether pH is roughly in range. It is not good enough to set a lime or sulfur rate.

How to read the report

Reports differ in layout, but they all carry the same parts.

pH and buffer pH

Soil pH is the acidity of the soil right now. Most vegetables want about 6.0 to 7.0. The scale is logarithmic: pH 6.0 is ten times as acidic as pH 7.0.

Buffer pH (some labs report "exchangeable acidity" or just "acidity") measures the reserve of acidity held on clay and organic matter. It is not a second opinion on the pH; it is the number the lab uses to work out how much lime it will take to move the pH. Two soils at pH 5.5 can need very different amounts. Many labs print a buffer pH only when lime might be needed. For what to do with the result, see soil pH: lime, sulfur and wood ash.

Phosphorus and potassium ratings

Read the rating before the number.

Rating What it means What to do
Low, below optimum The crop is likely to grow better if you add this nutrient Apply the recommended amount; it is set to build the soil up over a few years
Optimum, medium Adding more is unlikely to change the harvest Apply only the maintenance amount the report gives, which replaces what the crops remove
High, above optimum More will not help Add none of this nutrient
Excessive, very high Far more than plants can use; a pollution risk for phosphorus Add none, and cut back the materials that carry it

To give a sense of scale, Oregon State University's guide rates phosphorus on the Bray test as low below 20 ppm, medium at 20 to 40, high at 40 to 100 and excessive above 100; on the Olsen test the same four classes break at 10, 25 and 50 ppm. For potassium it gives low below 150 ppm, medium at 150 to 250, high at 250 to 800 and excessive above 800 ppm. Those figures apply only to those test methods. Check the units too: some labs report pounds per acre instead of ppm, and fertilizer recommendations are written as phosphate (P2O5) and potash (K2O), not as the elements.

What to do when phosphorus is excessive

Compost and manure carry more phosphorus, relative to nitrogen, than crops take up, so a garden fed with them for years climbs steadily. High phosphorus is not poisonous to plants or people, but the surplus washes into streams and lakes and feeds algae, and it holds back the mycorrhizal fungi on roots and can interfere with iron and manganese uptake (see amendment myths for the evidence on phosphorus).

  • Stop adding phosphorus: no bone meal, no "bloom booster", no balanced fertilizer such as 10-10-10. Minnesota's advice is to avoid phosphorus fertilizer for a few years once the Bray test is above 25 ppm.
  • Cut back or skip compost and manure until the level comes down.
  • Feed nitrogen from low-phosphorus sources such as blood meal or feather meal, and potassium, if the test calls for it, from potassium sulfate.
  • Keep organic matter up with cover crops instead of more compost; see cover crops.
  • Retest in three years. The level falls slowly as crops draw it down.

Calcium, magnesium and CEC

Cation exchange capacity (CEC) is the soil's capacity to hold positively charged nutrients such as calcium, magnesium and potassium on clay and organic matter. It runs from below 5 (in milliequivalents per 100 grams) in sandy soil that is low in organic matter to over 15 in finer soils. You can't change it much, and it doesn't need retesting. It mostly tells you how strongly the soil resists change: a high-CEC soil takes more lime or sulfur to shift.

Calcium is rarely short except in very acidic soil, and liming fixes it. Blossom end rot is not a sign of low soil calcium; see blossom end rot. Magnesium that tests low is usually corrected with dolomitic lime when the soil also needs liming. Some reports show base saturation, the share of the CEC taken up by calcium, magnesium and potassium. The University of Massachusetts lab states that no ideal ratio among them exists, so don't buy amendments to "balance" calcium against magnesium.

Organic matter

Cultivated soils in New England, for example, typically run 2 to 4 percent. Minnesota suggests adding compost when the figure is below 3 percent. It changes slowly, and labs measure it in different ways, so compare only results from the same lab.

Soluble salts

This is the total of dissolved fertilizer and manure salts. High readings burn roots and seedlings. On the Massachusetts lab's method most soils read between 0.08 and 0.50 dS/m, and sensitive plants such as onions can suffer above 0.60; a few inches of rain or irrigation leaches the excess. Labs that use a different method report on a different scale, so use the rating printed on your own report.

Why different labs' numbers do not match

A soil test does not measure all of a nutrient in the soil. The lab shakes the sample with an extracting solution and measures what comes out, and different solutions pull out different fractions.

Method Where you meet it
Mehlich-3 Penn State's lab and others
Modified Morgan The University of Massachusetts lab, and most New England university labs
Bray P1 Phosphorus on acidic to neutral soils; Minnesota uses it up to pH 7.4
Olsen Phosphorus on alkaline soils; Minnesota above pH 7.4, and the standard in Montana and eastern Oregon

The same soil gives a different number on each, and Montana State University's soil specialist notes there is no simple conversion from a Bray or Mehlich result to an Olsen one. Lead shows how far apart methods can be: on the Massachusetts lab's mild routine extraction, a reading of 22 ppm corresponds to roughly 300 ppm total lead.

So read the rating, not the raw number, never judge a result against a chart from another lab or a website, and send your samples to the same lab every time so that one test can be compared with the next.

Sources